Setting Up Wep Encryption Security - NETGEAR WNDA3100v2 - RangeMax Dual Band Wireless-N USB 2.0 Adapter User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100v2 User Manual
b. Click Apply, and then click Close to exit the Smart Wizard.

Setting Up WEP Encryption Security

Follow the steps below to configure WEP encryption security:
1. Run the WNDA3100v2 Smart Wizard.
a. Make sure that the WNDA3100v2 software is installed and the wireless-N USB adapter is
connected to the USB port in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab displays.
2. Configure the Security settings.
a. In the Profile field, select the profile or type in a profile name.
b. In the Network Name (SSID) field, select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
c. In the Security section, select WEP.
Figure 2-14
3. Select the WEP encryption strength you will use.
• 64-bit WEP data encryption
• 128-bit WEP data encryption
2-16
v1.0, June 2009