Panasonic HC-X900 Operating Instructions Manual page 82

∫
/
HC-X900 HC-X900M
To switch the image during the recording to 2D (3D) display
≥ Touch (left side)/
( ) is displayed only when the 3D Conversion Lens (optional) is attached.
≥
Touch ( ).
≥ 2D (3D) image will switch to 3D (2D) image.
≥ It is possible to set from the menu.
([SETUP] # [2D/3D DISPLAY])
To ensure that the 3D image can be safely viewed, pay attention to the following
points when recording.
≥ Where possible, record with the unit in a horizontal state.
≥ Do not get too close to the subject. (record from a distance of at least 1.2 m.)
≥ When moving the unit as you record, move it slowly.
≥ Try to hold the unit as steady as possible when recording while riding in a vehicle or walking.
≥ Use of a tripod is recommended for recording with a stable picture.
/
≥
HC-X900 HC-X900M
The reception range for the remote control might become narrow at the upper side of the
unit, so operate from the lower side. (l 44)
≥ [ECONOMY (BATT)]/[ECONOMY (AC)] will not work while you adjust the 3D Conversion
Lens attachment position.
≥ When the 3D Conversion Lens is attached, the auto slow shutter setting is [AUTO SLOW
SHTR (3D)]. The default setting of [AUTO SLOW SHTR (3D)] is [ON]. (l 64)
≥ While 3D recording if moving the unit fast, the message is more likely to appear.
≥
HC-X800
The LCD monitor on this unit will not display in 3D.
≥ If the unit is turned on with the lens cap attached in the shade etc., the screen may appear
to be blue. In such a case, remove the lens cap to return the screen to normal.
(right side) of on the Touch Menu to display
- 82 -
( ). (l 20)
Q.
MENU
MENU