Nokia N91 User Manual page 96

Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name—Select
netw.. If you select an existing network,
and WLAN security mode
of its access point device.
WLAN netw. mode—Select
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode—Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security sett.—Enter the settings for the selected
security mode:
Security settings for WEP:
Wep key in use—Select the WEP key number. You can create
up to four WEP keys. The same settings must be entered on
the wireless LAN access point device.
Authentication type—Select
authentication type between your device and the wireless
LAN access point device.
WEP key settings—Enter WEP encryption
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Enter manually or Search for
WLAN netw. mode
are determined by the settings
Ad-hoc to create an ad-hoc
Open or Shared for the
(length of the
or Hexadecimal), and WEP
Security settings for 802.1x
WPA mode—Select the means of authentication:
to use an extensible authentication protocol (EAP) plug-in,
or Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP)—Enter the settings
as your service provider instructs.
Pre-shared key (only for Pre-shared
The same password must be entered on the wireless LAN
access point device.
TKIP encryption—Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
device), Subnet mask (the subnet IP address),
gateway (the gateway), and
IP addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings > DNS address—Select Automatic,
Well-known, or User defined.
Ad-hoc channel (only for Ad-hoc)—To enter a channel
number (1-11) manually, select
Proxy serv. address—Enter the address for the proxy server.
Proxy port number—Enter the proxy port number.
and WPA/WPA2:
EAP
key)—Enter a password.
and from the
(the IP address of your
Default
DNS address—enter the
User defined.
95