Replace Light Bulb; Clearing Clog - Bissell 6585 SERIES User Manual

M
aintenance and care

Replace light bulb

Use only BISSELL Replacement Bulbs in your
BISSELL PowerForce Turbo Bagless.
1. Unplug cleaner from electrical outlet.
2. Using a flat screwdriver, table knife or coin,
insert into the slot on the right of the lens
and gently push inner latch to the left as
shown to remove the lens.
3. Remove the bulb from the socket by grasping
bulb and pulling straight out. Install the new bulb
by pushing it gently into the socket until the bulb
snaps into place.
5. Reposition lens, by inserting tab on left side and
then pushing the right side back into place.

Clearing clog

Low suction, poor pickup, or no suction may be
due to a clog in the vacuum cleaner. If you notice
a change in the sound of the vacuum motor or a
reduction in the spinning action in the dirt
container, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Empty dirt container.
3.
Check upper tank and
build up or clogs. Check to make sure
separator
primary separator
toward the left. Pull straight down to remove. If
primary separator
the
into place, check and clear the tube in the cen-
ter of the dirt container.
4. Remove the Twist 'n Snap hose from the
vacuum by turning to the left. Check the
suction inlet, hose and hose wand for clogs.
Remove any clogs from the hose using a
long, narrow object.
5. Check the foot hose for clogs. If needed,
remove the screw attaching the hose wand
base to the vacuum. Straighten the foot hose
and unclog with a long, narrow object.
6. If the clog persists, follow the instructions for
checking the rotating floor brush on page 11
and inspect the air passageway for obstructions.
12
w w w . b i s s e l l . c o m
ug110_4018_6585_1207.indd 12 ug110_4018_6585_1207.indd 12
primary separator
is installed correctly. To unlock the
, grasp the rim and turn
is missing or not locked
for
Suction
primary
Inlet
Primary
Separator
Hose
Wand Base
Air Passageway
8 0 0 . 2 3 7 . 7 6 9 1
12/19/07 10:05:00 AM 12/19/07 10:05:00 AM