Replace Light Bulb - Bissell LIFT-OFF 89Q9/18Z6 User Manual

M
aintenance and care
Replace drive belt continued
4. Pull the rotating floor brush firmly into
position, stretching the drive belt, and
place ends of rotating floor brush
down into the slots on sides as shown.
Alignment of brush ends in slots is
necessary to fully insert the brush.
5. Turn rotating floor brush by hand several
times in the direction of motor pulley. If
properly installed, drive belt will center
itself on rotating brush crown.
6. Reposition brush cover and screw back
into place.

Replace light bulb

1. Unplug cleaner from electrical outlet.
2. Remove detachable canister and recline
handle of vacuum.
3. Using a screwdriver, remove the one
screw as shown and lift off the lens.
4. Remove the bulb from the socket by
grasping bulb and pulling straight
out. Install the new bulb by pushing
it gently into the socket until the bulb
snaps into place.
5. Reposition lens and secure with the one screw.
Maintaining pet turboeraser™ tool
the pet turboeraser should be checked
regularly for clogs or debris wrapping
around the brush.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible,
unscrew the two screws on the back of the
Pet TurboEraser to remove the faceplate and
clear any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush.
Place ends of brush in slots on sides.
Reposition faceplate and secure with
two screws.
w w w . b i s s e l l . c o m
WaRning:
To reduce the risk of electric
shock, turn power switch OFF and
disconnect polarized plug from
electrical outlet before performing
maintenance or troubleshooting
checks.
3.
2.
4.
8 0 0 . 2 3 7 . 7 6 9 1
4.
13