Bissell 6585 SERIES User Manual page 13

T
roubleshooting
Vacuum cleaner won't turn
Possible causes
1. Power cord not firmly plugged in
2. Blown fuse/tripped breaker
Vacuum cleaner won't pick up dirt
Possible causes
1. Incorrect height adjustment
2. Hose not attached to suction opening
3. Twist 'n Snap hose not securely attached
4. Crack or hole in hose
5. Broken or worn drive belt
6. Rotating floor brush bristles worn
7. Rotating floor brush jammed
8. Clog in vacuum
9. Dirt container full
10. Dirt container not installed properly
11. Filters are dirty
12. Primary separator missing or installed incorrectly
13. TurboBrush is clogged
wrapped around the brush
Tools won't pick up dirt
Possible causes
1. Crack or hole in hose
2. Vacuum hose, wand or tools clogged
3. Dirt container full
4. Dirt container or upper tank not installed properly
5. Filters are dirty
6. Primary separator missing or installed incorrectly
w w w . b i s s e l l . c o m
ug110_4018_6585_1207.indd 13 ug110_4018_6585_1207.indd 13
WARNING:
To reduce the risk of electric shock, turn
power OFF and disconnect polarized plug
from electrical outlet before performing
maintenance or troubleshooting.
or debris is
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker.
Remedies
1. Adjust powerfoot to correct height setting
2. Grasp quick release handle and firmly push
hose wand onto the suction opening.
3. Make sure Twist 'n Snap hose is snapped
into locked position
4. Check hose and replace if needed
5. Replace drive belt, see page 11
6. Replace brush
7. Remove brush and clean debris from brush ends
8. Follow instructions for clearing
clogs on page 12
9. Empty dirt container
10. Position correctly and lock in place
11. Check and clean inner and outer circular
filters, pre-motor and post-motor filters
12. Check for a clog in the tube in the center of the
dirt container, clear and properly install
primary separator
12. Maintaining TurbBrush, see page 10
Remedies
1. Check hose and replace if needed
2. Follow instructions for clearing clogs on
page 12
3. Empty dirt container
4. Position correctly and lock in place
5. Check and clean inner and outer circular
filters, pre-motor and post-motor filters
6. Check for a clog in the tube in the center of the
dirt container, clear and properly install
primary separator
8 0 0 . 2 3 7 . 7 6 9 1
13
12/19/07 10:05:02 AM 12/19/07 10:05:02 AM