Table of Contents
Advertisement
4.
Remove the centre hinge and slide
the top door off pin (D); unscrew
pin (D) and refit it on the opposite
side.
5.
Remove the two plugs, to reveal
the holes for the hinge pivots, and
remount them on the other side.
6.
Refit the top door and the centre
hinge (H) on the opposite side.
7.
Refit the bottom door.
8.
Refit bottom hinge (E) on the
opposite side, using the two
screws previously removed.
9.
Remove blanking cover (F) from
ventilation grille (D) by pushing it in
the direction of the arrow and refit
it on the opposite side.
10.
Refit ventilation grille (D), clipping
it into place.
11.
Unscrew the handle. Refit it on
opposite side after having pierced
the plugs with a punch. Cover the
holes left open with the plugs con-
tained in the documentation pack.
Attention:
After having reversed the opening
direction of the doors check that all
the screws are properly tightened
and that the magnetic seal adhe-
res to the cabinet. If the ambient
temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to
the cabinet. in that case, wait for
the natural fitting of the gasket or
accelerate this process by heating
up the part involved with a normal
hairdrier.
D590
PR24
PR228
D
H
9
Advertisement
Table of Contents
