Mazda RX-8 Owner's Manual page 256

RX-8_8BQ7-EA-10H_Edition1 Page256
Wednesday, July 14 2010 11:51 AM
Interior Comfort
Audio System
NOTE
Master code:
The Master Code is used to initialize or re-
initialize the ID code in the event that the code
is not set to [0000] and/or the personalized ID
code is not known. The initialization process
resets the ID code to [0000]. The master code
can potentially defeat the intent of the security
of the parental lock if it is located by persons
not authorized by the owner to access certain
channels.
SIRIUS Satellite Radio Master Code: [0913]
NOTE
When a numeric value other than the
l
master code is input and the auto memory
button is pressed, SR1 Err is displayed
and then it returns to the SR1 - - - -
display again.
If an ID code is not input for ten seconds,
l
Err is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
auto memory button are used for inputting
the ID code. Buttons 5 and 6 cannot be
used.
Change of ID code
Setting condition: SAT mode
When changing the ID code, the new ID
code is input after the previous one is
input first.
(Registered ID code input)
1. Press and hold the auto memory
button, then press channel preset button
5. Hold both buttons together for 1.5
seconds.
2. ENTER PIN appears for two seconds
which indicates that it is in code input
mode.
6-40
Form No.8BQ7-EA-10H
Black plate (256,1)
3. SR1 - - - - appears, which indicates
that it is ready for code input.
4. Input the registered ID code using
channel preset buttons 1-4.
Example: When the registered ID code
is 2323 , input 2323 . At this time
SR1 2323 is displayed.
Press 1 for the first digit, 2 for the
second, 3 for the third, and 4 for the
last digit. For example, if your number
is 2323, press 1 three times (includes
0), 2 four times, 3 three times, and 4
four times. If the display goes off while
inputting, begin from Step 1.
NOTE
The registered ID code is the default [0000] at
the time of factory shipment. If [0000] results
in Err on the display, go to the
INITIALIZATION OF ID CODE section to
reset to [0000].
(Verification with the registered ID
code)
5. Determine the input code by pressing
the auto memory button.
6. If it does not match with the previously
registered code, SR1 Err is displayed
and then it returns to SR1 - - - - .
7. If it matches with the previously
registered code, ENTER PIN appears
again and it switches to code input
mode.
8. SR1 - - - - appears, and it is ready for
input of the new ID code.
(New ID code input)
9. Input the new ID code using channel
preset buttons 1-4.
Example: If 1234 is input as the new
code, SR1 1234 is displayed.