Users Guide; To Turn The Heater On - lifeSMART LS-1500X-6WB Owners Installation And Operating Manual

Plug your Infrared Heater power cord into a 120V, 15amp (or higher) three-prong receptacle.

To Turn the Heater On:

Press the "Power" button on the front control panel or "ON/OFF" button on the remote control.
Heater Default Temperature:
The heater's default temperature every time it is powered "on" is 72° F.
• Note that the heater will not activate its heat elements or fan, if the starting ambient
temperature (temperature in the room) is above 72° F.
• If this is the case, the set desired temperature must first be adjusted above the ambient
temperature.
Ambient Temperature (room temperature)
the "Temp up" and "Temp down" buttons at the same time for appx 3 seconds. The room
temperature will display for 5 seconds then return to the desired set temperature.
Set Desired Temperature (Goal Temperature)
button on the control panel or on the remote control to select the Set Desired Temperature. The
heating process will begin.
• When the heater detects that the ambient room temperature matches the set desired
temperature, the heating will stop automatically.
• The fan will continue to run for a few extra minutes so that the unit's chamber can cool,
then the fan will also shut off. When the ambient temperature drops below the set desired
temperature once again, the heater will restart the heating cycle.
To Set Heat Mode:
remote control to switch between the High, Low, and Eco modes. The corresponding High, Low
or Eco light will switch on. Note that in all modes, the fan speed will remain the same.
USER'S GUIDE
Press the "High/Low/Eco" button on the control panel or "H/L/E" on the
:
To view the ambient room temperature, press
:
Press the "Temp up" or "Temp down"
11