Operation - Berkel C32 Owner's/Operator's Manual

Hide thumbs Also See for C32:

Table of Contents

To eliminate a potential shock hazard, a properly grounded outlet using the three-

pronged plug provided must power this unit. Before plugging the food processor in, check your

outlet voltage to be sure it complies with the voltage specified on the serial number plate on the

food processor.

General:

Safety check before processing with the feeder. remove the feeder, any cutting tools and the

ejector plate in accordance with the instructions under the heading "Removing the Feeder", and

then check that the machine will not start when the variable speed control is in the "i", "ii" or

"p" positions.

place the feeder on the machine base with the text "close open" at 5 o'clock in relation to the

outlet of the machine base and turn the feeder clockwise as far as it will go and is firmly in posi-

tion. then check that the machine stops when the feeder handle is raised and restarts when the

feeder handle is lowered, with the variable speed control in the "i", "ii" or "p" positions.

Set the variable speed control to position "ii" and then lift the feeder handle and check that the

shaft stops rotating within 4 seconds.

Safety check before processing with the bowl. First remove the lid, the knife and the bowl in ac-

cordance with the instructions under the heading "Removing the Bowl", and then check that the

machine will not start when the variable speed control is in the "i", "ii" or "p" positions.

install the bowl and lid (but not the knife) in accordance with the instructions under the heading

"Installing the Bowl" and set the variable speed control to the "ii" position. remove the lid by

turning it counterclockwise and check that the shaft stops rotating within 4 seconds.

in the event of any fault or malfunction, call in an authorized service technician to correct the fault be-

fore using the machine.

Continuous Feed Operation:

the continuous Feed attachment is used together with a suitable cutting tool for slicing, dicing,

shredding or grating.

the large feed compartment is used mainly for feeding potatoes, onions, peppers, etc. and cutting

larger foods such as cabbage. the large feed compartment is also used when the food has to be

cut/sliced in a specific direction, e.g. when slicing tomatoes and lemons.

the feed tube is mainly used in connection with processing elongated foods such as cucumbers.

peraTion

– 8 –

Table of Contents

Cc34 B32