General; Introduction; Specifications; Cleaning Procedures - Berkel CC34 Service Manual

INTRODUCTION

This manual covers Models CC34, B32, and C32
Food Processors.

SPECIFICATIONS

Operating voltage
Current

CLEANING PROCEDURES

Never clean machine with a high pressure hose, with
steam injection equipment or in a dishwasher.
Detailed cleaning procedures are included in
Instruction manual for this model.

OPERATION

Start-up Test
1. With the feeder, any cutting tools, and ejector
plate removed, check that the machine will not
start when variable speed control is in I, II, or P
position.
2. With feeder on machine base, check that the
machine stops when feeder handle is raised and
re-starts when feeder handle is lowered, with
variable speed control in I, II, or P position.
3. Check that shaft stops rotating within four
seconds when feeder handle is lifted and variable
speed control is in II position.
Detailed operation procedures are included in the
Instruction manual for this model.

TOOLS

• Standard set of hand tools
• Set of Torx drivers
• VOM with measuring micro amp current tester.
Any VOM with minimum of CAT III 600V, CE
certified. Sensitivity of at least 20,000 ohms per
volt can be used. In addition, meter leads must
also be a minimum of CAT III 600V.
• Loctite® No. 222
Food Processer - GENERAL

GENERAL

100-120/50-60/1
10 amps
Page 3 of 13

LUBRICATION

Chevron FM ALC EP - 2 used in bowl drive gear case.
F25264 (0116)