Table of Contents
Advertisement
Starting up and temperature regulation
Insert the plug of the connection lead into the plug socket with pro-
tective earth contact. When the refrigerator compartment door is ope-
ned, the internal lighting is switched on.
The temperature selector knob is
located on the RH side of the refriger-
ator compartment.
Setting "0" means: Off.
Turning clockwise in direction "1":
Refrigerating unit on, the latter then
operating automatically.
Setting "1" means:
AEG62
Hightest temperature, warmest setting.
Setting "6" (end-stop) means:
Lowest temperature, coldest setting.
At a low ambient temperature of around 16°C, setting "1" should be
selected. At ambient temperatures of around 25°C, select setting "2". If
you require a lower temperature, select setting "3" or "4".
Important!
High ambient temperatures (e.g. on hot summer days) and a cold set-
ting on the temperature regulator (position"5" to "6") can cause the
compressor to run continuously.
Reason: when the ambient temperature is high, the compressor must
run continuously to maintain the low temperature in the appliance.
The fridge will not be able to defrost since automatic defrosting of the
fridge is only possible when the compressor is not running (see also
"Defrosting" section). The result is the build up of a thick layer of frost
on the fridge rear wall.
If this happens, turn the temperature regulator back to a warmer set-
ting (position "3" to "4"). At this setting the compressor will be
switched on and off as usual and automatic defrosting recommenced.
12
Advertisement
Table of Contents
