Heart Rate Priority - Nautilus T9.14 Owner's Manual

Both contact heart rate and telemetry (e.g., Polar®) heart rate signal detection is available. The default
priority of heart rate input is LOCKED INPUT. If a telemetry signal is detected first, contact heart rate signals
are inhibited from being detected throughout the rest of the workout session and vice-versa.
Locked/Non-Locked Heart Rate Signal Options
When the EITHER INPUT option is selected the heart rate source signal is not fixed during the workout session
(if the signal is lost either input will be valid). If the LOCKED INPUTS option is selected then the heart rate
source signal is locked on the first detected signal during the workout. To set a heart rate signal input, or to
turn off the heart rate option all together, perform the following steps:
1. On the console keypad, press [Speed: UP], [3],
[2]. At this point the screen will display HR
INPUTS. Press [ENTER] to select this option.
2. There are five options to handle heart rate input
signals. Press the [Speed: UP] and [Speed:
DOWN] keys to scroll through the options until
you find the option that you want. Press the
[ENTER] key to select that option.
The options are as follows:
LOCKED INPUTS – allows either telemetry or
contact heart rate signals to be detected. Once
the console has detected a valid input signal it
will lock out the opposite type of signal for the
duration of the workout session. For example,
if you start out using contact heart rate then
you are limited to using only contact heart rate
during your workout session, even if the signal
is lost while performing the workout, and
vice-versa.
EITHER INPUT – allows either telemetry or
contact heart rate signals to be detected. Does
34
C H A N G I N G T H E G A M E I N H E A LT H A N D F I T N E S S

HEART RATE PRIORITY

not lock out a particular input signal for the
entire workout. This option will detect either
input signal during a workout session, but only
one at a time, and only until the other signal
terminates.
TELEMETRY ONLY – locks out contact heart
rate signals and will only detect telemetry
signals.
HAND ONLY – locks out telemetry signals and
will only detect contact heart rate signals.
BOTH HR OFF – turns off the ability to detect
any heart rate signal. Used in rare situations
where there is excessive interference with the
heart rate signals.
• During workouts where heart rate is
necessary, such as the HR Zone Trainer and
the Fitness Test, the console will pick up
telemetry heart rate signals so that the
programs are not disabled.
™