What Next - MOTU MIDI Timepiece AV User Manual

G L O B A L H A R D W ARE
S E T U P
Figure 3-5
3 Once you see Figure 3-5 in the display, turn the
CURSOR knob clockwise two clicks.
Now you should see what is shown below in
Figure 3-6, and the phrase "1–8" should be
blinking to indicate that it can be changed with the
VALUE knob.
T H I S B O X I D 1-8
N E T P O R T = M AC
D
Figure 3-6
4 Choose the appropriate setting (1-8 or 9-16) by
turning the VALUE knob.
If you are currently setting up the first MIDI
Timepiece AV-USB in the network, choose 1-8. If
you are setting up the second MIDI Timepiece,
choose 9-16. Make sure that the box ID's on two
networked MIDI Timepieces are never the same.
One MIDI Timepiece should always be set to
Box 1-8 and the other to Box 9-16.
5 Once you have chosen the correct box ID above,
turn the CURSOR knob clockwise one click.
Now the word "MAC" flashes to indicate that it can
be edited with the VALUE knob.
22
6 Turn the VALUE KNOB to the setting that
describes what is connected to the network port on
this MIDI Timepiece.
E
If this is connected
Nothing, a second computer, a third
party MIDI interface, or a serial port
device (such as a MIDI synth with a
serial port connector)
A MIDI Timepiece I, II, AV, or
AV-USB
You have completed the installation of a two-MTP
network.

WHAT NEXT?

You're ready to install software. Turn to chapter 4,
E
"Installing the MOTU USB Software" (page 23).
I N S T A L L I N G M U L T I P L E I N T E R F A C E S
Choose this
MAC
MTP