Mercedes-Benz ML350 Operator's Manual page 459

Practical hints
Flat tire
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with
wrench).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
!
Do not position the jack on the body of
the vehicle, as this may cause damage
to the vehicle.
458
1 Take-up bracket
2 Jack
!
Vehicles with factory-mounted
running-boards*:
Your vehicle is equipped with a scis-
sors-type jack (located under the cargo
compartment floor) designed for use
with factory-mounted running boards.
Only use this jack when jacking up ve-
hicles with factory-mounted running
boards as otherwise the vehicle's
underbody can be damaged. See sepa-
rate instructions for scissors-type jack.
Place jack 2 on firm ground.
Position jack 2 under the take-up
bracket 1 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an in-
cline.
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while vehi-
cle is raised.