Power Door Lock Disabled; The Unlock Feature Will Work Again After...; Sounding A Personal Alarm; Replacing The Battery (Remote Entry Transmitter) - Mazda B4000 Owner's Manual

Power door lock disabled

The UNLOCK feature on your power
door locks will not work from inside
the vehicle when:
the ignition has been turned to the OFF position, and
20 seconds elapse after all vehicle doors are closed and locked using
the remote entry transmitter, or the power door lock control (while
the accompanying door is open).
The UNLOCK feature will work again after:
a door has become ajar,
the ignition is turned to the ON position, or
using the UNLOCK

Sounding a personal alarm

Press to activate the alarm. The horn will sound for a maximum of
30 seconds and the parklamps will flash for a maximum of 3 minutes.
Press again or turn the ignition to ON to deactivate, or wait for the alarm
to timeout in 3 minutes.
Note: The personal alarm will only operate when the ignition is in the
OFF or ACC position.
Replacing the battery
The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent. The typical operating range for your
remote entry transmitter is approximately 10 meters (33 feet). A
decrease in the operating range could be caused by:
weather conditions,
nearby radio towers,
structures around the vehicle and
other vehicles parked next to the vehicle.
Locks and Security
control on your remote entry transmitter.
UNLOCK
LOCK
57