How To Use; Care And Cleaning - Belson MH5011 Use And Care Book Manual

MH5011Pub500423 7/9/04 11:24 AM
IMPORTANT:
Wires in this mains lead are coloured in accordance with the following code:
Blue – Neutral
Brown – Line
As the colours of the wires in the mains lead of the appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
• The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or is coloured black.
• The wire which is coloured brown must be connected to the terminal which
is marked with the letter L or is coloured red.
If a 13-amp plug is used, a 5-amp fuse must be fitted or if any other type of plug
is used, a 5-amp fuse must be fitted either in the plug or adaptor, or at the
Distribution Board.
This product has been tested and manufactured in accordance with the British
Safety Regulations.

How to Use

This appliance is for household use and can be plugged into any AC electrical
outlet.
GETTING STARTED
IMPORTANT: During the first few minutes of use, you may notice smoke and
a slight odor. This is normal and will quickly disappear.
WARNING: This multiple temperature, triple-barrel waver has been specially
designed for very coarse, thick, hard-to-curl hair.
Due to this special application, the barrels will be very hot in the HIGH (21-30)
settings. Be very careful when using it.
• Keep unit away from contact with all skin areas.
• Do not touch barrels with fingertips.
• For shorter hair, place a thin plastic comb between scalp and barrels to avoid
touching the scalp.
• Test a small section of hair before using.
SPECIAL FEATURE
The solid-state circuitry in this triple-barrel waver has a sensor that detects
temperature loss and boosts the power to bring the heat level back to optimum
styling temperature. This allows you to style the hair in half the time it takes with
ordinary curling irons.
Page 4
3
PREHEATING
1. Rest the triple-barrel waver on its safety stand on a flat, smooth surface and
plug into an electrical outlet.
2. Turn on the triple-barrel waver with the temperature control and set it to
the appropriate setting for your hair type. It will take 60-90 seconds for the
triple-barrel waver to heat up. For optimum styling performance, let the waver
continue to heat for about 2 to 3 minutes before using.
HEAT SETTINGS
Hair Type Heat Setting
Very coarse, highly resistant
Dense, hard-to-curl
Thick and wavy
Easy-to-curl, normal
Very fine, fragile, light colored
STYLING
For a complete styling, hair should be clean and dry.
1. Section hair into strands of no more than 1/2-inch thick and 2 inches wide.
2. Press clamp to open waver.
3. Place sectioned strands between waving barrels.
4. Close clamp for a few seconds while heat sets the wave.
5. Press clamp to open waver and release hair.

Care and Cleaning

This appliance requires little maintenance and contains no user serviceable parts.
CLEANING
1. Unplug triple-barrel waver and let it cool. Clean only when it is cold.
2. Use a soft, slightly damp cloth to wipe the handle.
3. Do not allow water or any other liquid to go into the handle.
STORAGE
• Unplug appliance and let it cool.
• Store in a clean, dry place.
• Never wrap the cord around the unit; this could cause the cord to wear
prematurely and break.
• Do not put any stress on the cord where it enters the handle, as it could cause
the cord to fray and possibly break.
• Never hang unit by the power cord.
HIGH (21-30)
MED/HIGH (16-20)
MEDIUM (13-15)
LOW/MEDIUM (6-12)
LOW (1-5)
4