Intel WSAP5000 - PRO/Wireless 5000 LAN Access Point Quick Installation Manual page 10

The Reset button is located in a pinhole on the bottom of the access point.
Insert the end of an unbent paper clip into the hole and apply pressure as
follows:
•
Press and release the Reset button quickly to perform a hardware reset.
•
Press and hold the Reset button until the "Ready" LED flashes quickly 3
times. This will restore all access point parameters to factory default
settings, including default user name, password, and IP address.
Access Point Factory Default Settings
Access point WSAP5000 (or the model number of your access
name point)
IP address 192.0.2.1
Subnet mask
255.255.0.0
Default gateway
None
User
Intel (case sensitive)
Password Intel (case sensitive)
SSID 11A 101
WEP 11A Disabled
SSID 11B 101
WEP 11B Disabled
Set Up a Wireless LAN
For detailed information on site survey, setup, positioning, and testing of
access points on your wireless LAN, see the online user guides on the Intel
CD-ROM.
10