Behringer TUBE OVERDRIVE TO100 Manual

TUBE OVERDRIVE TO100
Authentic Tube-Sound Overdrive Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER TUBE OVERDRIVE TO100.
This high-quality effects pedal is ideally suited for giving electric guitars maximum flexibility with
state-of-the-art overdrive sounds that capture every nuance of your playing—from smooth overdrive
to screaming tube sounds. Thanks to its high-performance features you get tube-like distortion,
smooth sustain and super fat tone.
1. Controls
(1)
(3)
(7)
(1) The DRIVE control adjusts the intensity of the overdrive effect.
(2) The LEVEL control adjusts the output level.
(3) The TONE control allows you to shape your overall sound.
(4) The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
(5) Use the footswitch to activate/deactivate the effect.
(6) Use this 1/4" TS IN connector to plug in the instrument cable.
(7) The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
◊
The TO100 has no on/off switch. As soon as you insert the jack into the in connector,
the TO100 begins running. When not using the TO100, remove the jack from the in
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
(4)
(2)
(6)
(5)