Gigabyte GA-H67MA-UD2H User Manual page 88

C. Rebuilding an Array
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies
only to fault-tolerant arrays such as RAID 1, RAID 5 or RAID 10 arrays. The procedures below assume a new
drive is added to replace a failed drive to rebuild a RAID 1 array. (Note: The new drive must have equal or
greater capacity than the old one.)
Turn off your computer and replace the failed hard drive with a new one. Restart your computer.
• Enabling Automatic Rebuild
Step 1:
When the message "Press <Ctrl-I> to enter Configuration Utility" appears, press <Ctrl> + <I> to enter the
RAID Configuration Utility. The following screen appears after you enter the RAID Configuration Utility.
1. Create RAID Volume
2. Delete RAID Volume
"Degraded volume and disk available for rebuilding detected. Selecting
a disk initiates a rebuild. Rebuild completes in the operating system.
Select the port of the destination disk for rebuilding (ESC to exit):
RAID Volumes :
Port Drive Model
None defined.
1 WDC WD800JD-22LS
Physical Disks :
Port Drive Model
0 ST3120026AS
1 WDC WD800JD-22LS
[ hi ]-Select
Step 2:
Select the new hard drive to add into the array to be rebuilt and press <Enter>. The following screen appears,
indicating that an automatic rebuild will be performed after you enter the operating system (look for the Intel
Rapid Storage Technology icon
rebuilt). If you do not enable automatic rebuild on this stage, you have to manually rebuild the array in the
operating system (see the next page for more details).
1. Create RAID Volume
2. Delete RAID Volume
RAID Volumes :
ID Name
0 Volume0
Physical Devices :
Port Devices Model
0 ST3120026AS
1 WDC WD800JD-22LS
[ hi ]-Select
Appendix
Intel(R) Rapid Storage Technology - Option ROM - 10.0.0.1046
Copyright(C) 2003-10 Intel Corporation. All Rights Reserved.
[ DEGRADED VOLUME DETECTED
[ DISK/VOLUME INFORMATION ]
[ hi ]-Previous/Next
Serial #
3JT354CP
WD-WMAM9W736333
in the notification area, which will show that a RAID volume is being
Intel(R) Rapid Storage Technology - Option ROM - 10.0.0.1046
Copyright(C) 2003-10 Intel Corporation. All Rights Reserved.
[ DISK/VOLUME INFORMATION ]
Level
RAID1(Mirror)
Serial #
3JT354CP
WD-WMAM9W736333
Volumes with "Rebuild" status will be rebuilt within the operating system.
[ MAIN MENU ]
Serial #
WD-WMAM9W736333
[ENTER]-Select
Size
111.7GB
111.7GB
[ESC]-Exit
[ MAIN MENU ]
5. Exit
Strip Size
N/A 111.7GB
Size
111.7GB
111.7GB
[ESC]-Exit
- 88 -
]
3. Reset Disks to Non-RAID
4. Exit
Size
111.7GB
[ESC]-Exit
Type/Status(Vol ID)
Member Disk (0)
Non-RAID Disk
[ENTER]-Select Menu
3. Reset Disks to Non-RAID
4. Recovery Volume Options
Status Bootable
Rebuild Yes
Type/Status(Vol ID)
Member Disk (0)
Member Disk (0)
[ENTER]-Select Menu