Gigabyte GA-H67MA-UD2H User Manual page 83

Step 5:
Enter the array capacity and press <Enter>. Finally press <Enter> on the Create Volume item to begin creat-
ing the RAID array. When prompted to confirm whether to create this volume, press <Y> to confirm or <N> to
cancel (Figure 6).
[ hi ]-Change
When completed, you can see detailed information about the RAID array in the DISK/VOLUME INFORMA-
TION section, including the RAID level, stripe block size, array name, and array capacity, etc. (Figure 7)
1. Create RAID Volume
2. Delete RAID Volume
RAID Volumes :
ID Name
0 Volume0
Physical Devices :
Port Device Model
0 ST3120026AS
1 ST3120026AS
[ hi ]-Select
To exit the RAID BIOS utility, press <Esc> or select 5. Exit in MAIN MENU.
Now, you can proceed to create the SATA RAID/AHCI driver diskette and install the SATA RAID/AHCI
driver and operating system.
Intel(R) Rapid Storage Technology - Option ROM - 10.0.0.1046
Copyright(C) 2003-10 Intel Corporation. All Rights Reserved.
[ CREATE VOLUME MENU ]
Name : Volume0
RAID Level : RAID0(Stripe)
Disks :
Strip Size : 128 MB
Capacity : 111.7 GB
WARNING : ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N) :
Press ENTER to create the specified volume.
[TAB]-Next
Intel(R) Rapid Storage Technology - Option ROM - 10.0.0.1046
Copyright(C) 2003-10 Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Level
RAID0(Stripe)
Serial #
3JT354CP
3JT329JX
[ESC]-Exit
Select Disks
Sync : N/A
Create Volume
[ HELP ]
[ESC]-Previous Menu
Figure 6
5. Exit
Strip Size
128KB 223.6GB
Size
111.7GB
111.7GB
Figure 7
- 83 -
[ENTER]-Select
3. Reset Disks to Non-RAID
4. Recovery Volume Options
Status Bootable
Normal Yes
Type/Status(Vol ID)
Member Disk(0)
Member Disk(0)
[ENTER]-Select Menu
Appendix