NAME OF PARTS
Fig. 1 Indoor Unit
Intake Grilles
UV Lamp (4 position)
Indicator (Fig. 2)
MAINTENANCE SIGN Indicator Lamp (red)
TIMER Indicator Lamp (green)
OPERATION Indicator Lamp (red)
SUPER QUIET Indicator Lamp (green)
HI-POWER Indicator Lamp (orange)
Remote Control Signal Receiver
Open Panel (Fig.3)
MAINTENANCE/MANUAL AUTO button
G
When kept on pressing the MANUAL AUTO
button for more than 10 seconds, the forced
cooling operation will start.
G
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's use.
G
When the forced cooling operation starts by
any chance, press the START/STOP button
to stop the operation.
Air Filter
Dust Box
Air Flow Direction Louver
Right-Left Louver
(behind Air Flow Direction Louver)
Power Diffuser
Power Supply Cord
Power Supply Plug
Fig. 4 Outdoor Unit
Intake Port
Outlet Port
Pipe Unit
Drain Port (bottom)
G Refer to the folded out page on the cover.
En-3
Fig. 5 Remote Controller
Signal Transmitter
Remote Controller Display (Fig. 6)
COIL DRY Display
Operating Mode Display
FAN CONTROL Display
ECONOMY Operation
Transmit Indicator
Temperature Display
SWING Display
Battery Indicator Display
ON TIMER Display
OFF TIMER Display
START/STOP button
SET TEMP. button (
/
)
COOL button
DRY button
HEAT button
SLEEP button
AUTO button
FAN button
COIL DRY button
FILTER button
HI-POWER button
SUPER QUIET button
FAN CONTROL button
ECONOMY button
SWING button
AIR DIRECTION (Left-Right) button
AIR DIRECTION (Up-Down) button
ON TIMER button
OFF TIMER button
SET TIME buttons (
/
SET (TIMER) button
CANCEL (TIMER) button
TEST RUN button
RESET button
CLOCK ADJUST button
)