ECS 915PL-A2 User Manual page 26

20
Follow these instructions to install add-on cards:
1. Open the chassis and then remove the slot bracket from the case where you will
be installing the expansion cards.
2. Install your graphics card in the proper slot by pressing the card firmly into the
slot.
3. Drive in the screw to secure the slot bracket of the expanson card.
4. Replace your computer's chassis cover.
5. Power on the computer, if necessary, set up BIOS utility of expansion card from
BIOS.
6. Install related driver to complete the installation.
Notes: 1. The two PCIE x16 slots run in two modes. With only one PCI Express
2. The Scalable D.G.E. supports a four-monitor configuration when PCIE x16
3. Please note that the graphics card driver supports Windows 2000/XP only.
4. Make sure to connect a 4-pin ATX power cable to the ATX4P1; otherwise,
Installing two graphics cards
Graphics card, install it onto PCI-E1 slot by default. Having two PCI
Express Graphics cards at hand, set them up onto PCI-E1 and PCI-E3
slots simultaneously.
slot and PCIEx4 slot are working simultaneously.
the system will be unstable.
Installing the Motherboard