Sewing Heavyweight Fabrics; If The Fabric Does Not Fit Under The Presser Foot; If The Fabric Does Not Feed - Baby Lock ellegante 2 BLG2 Instruction And Reference Manual

Sewing Heavyweight Fabrics

The sewing machine can sew fabrics up to 6 mm
(approx. 1/4 inch) thick. If the thickness of a seam
causes sewing to occur at an angle, help guide the
fabric by hand and sew on the downward slope.
CAUTION
• Do not forcefully push fabrics more than 6 mm
(approx. 1/4 inch) thick through the sewing
machine. This may cause the needle to break
and cause injury.
■ If the Fabric does not Fit under the
Presser Foot
If the presser foot is in the up position, and you are
sewing heavyweight or multiple layers of fabric
which do not fit easily under the presser foot, use
the presser foot lever to raise the presser foot to its
highest position. The fabric will now fit under the
presser foot.
Memo
You cannot use the presser foot lever after
the presser foot has been raised using the
"Presser Foot Lifter" button.

■ If the Fabric does not Feed

If the fabric does not feed when starting to sew or
when sewing thick seams, press the black button on
the left side of presser foot "J".
a
Raise the presser foot.
b
While keeping the black button on the left
side of presser foot "J" pressed in, press the
"Presser Foot Lifter" button to lower the
presser foot.
c
Release the button.
→ The presser foot remains level, enabling the fabric to
be fed.
Memo
• Once the trouble spot has been passed, the
foot will return to its normal position.
• When "AUTOMATIC FABRIC SENSOR
SYSTEM" (Automatic Presser Foot
Pressure) in the machine settings screen is
set to "ON", the thickness of the fabric is
automatically detected by the internal
sensor so the fabric can be fed smoothly for
best sewing results. (See page 55 for
details.)
SEWING
2
47