Baby Lock Decorator's Choice BLDC2 Instruction And Reference Manual page 25

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
k While holding the thread with your left hand,
wind the thread that was pulled out clockwise
around the bobbin five or six times with your
right hand.
Note
Make sure that the thread between the spool
and the bobbin is pulled tight.
Be sure to wind the thread clockwise around
the bobbin, otherwise the thread will
become wrapped around the bobbin winder
shaft.
l Pass the end of the thread through the guide
slit in the bobbin winder seat, and then pull
the thread to the right to cut it.
a Guide slit in bobbin winder seat
(with built-in cutter)
The thread is cut to a suitable length.
CAUTION
● Be sure to cut the thread as described. If
the bobbin is wound without cutting the
thread using the cutter built into the slit in
the bobbin winder seat, the thread may
become tangled in the bobbin and the
needle may bend or break when the
bobbin thread starts to run out.
1
m Slide the sewing speed controller to the right
to increase the bobbin winding speed and slide
to left to decrease.
a Sewing speed controller
n Press / ("Start/Stop" button) once.
1
a "Start/Stop" button
• When the bobbin winding becomes slow,
press / ("Start/Stop" button) once
to stop the machine.
CAUTION
● When the bobbin winding becomes slow,
stop the machine, otherwise the sewing
machine may be damaged.
o Use scissors to cut the end of the thread
wound around the bobbin.
p Slide the bobbin winder shaft to the left.
Winding/Installing the Bobbin 23
1
1