Turning Your Device On And Off - Kyocera Echo M9300 User Manual

Turning Your Device On and Off

Turning Your Device On
Press and hold
seconds.
Once your device is on and finds a signal, it
automatically enters standby mode – the device's idle
state. At this point, you are ready to begin making and
receiving calls.
If your device is unable to find a signal after five
minutes of searching, a Power Save feature is activated
and your device searches for a signal periodically
without your intervention. When a signal is found, your
device automatically returns to standby mode.
Tip:
The Power Save feature conserves your battery power
when you are in an area where there is no signal.
Turning Your Device Off
1.
Press and hold
window.
Phone options
2.
Tap Power off > OK
12 2A. Device Basics
for approximately two
until you see the
to turn the device off.
Turning Screen Lock On or Off
To save your battery or prevent accidental touches,
your device automatically turns off the display screen
and lock the screen after the time specified for the
screen timeout. (See "Changing the Backlight Time
Length" on page 52 for details.)
To unlock the display screen:
1. Press to wake up the screen.
2.
From the lock screen, flick
To lock the display screen manually:
Press . (Once your backlight turns off, your
device locks.)
To wake up the screen, just press
Note:
During a call, the screen will automatically turn off when
no operation is performed for about 15 seconds
(regardless of the screen timeout setting).
If you've locked your screen, you must draw an unlock
pattern or enter a PIN or password to unlock it. See
"Setting the Screen Lock" on page 61.
.
again.