Setting Surface Controls; Burner Locations - Electrolux 316520001 Use And Care Manual

Setting Surface Controls

16
Operating single burners
1. Push the desired gas surface control knob in and
turn counterclockwise out of the OFF position -
Fig.1.
2. Release knob and rotate to
Visually check that the needed burner has lit.
3. To adjust, push the knob in and turn counter-
clockwise to a flame size setting that best fits
your need.

Burner locations

Standard burners -9,500 BTU- best for most
surface cooking requirements.
Large burner -14,000 BTU- best for bringing
large quantities of liquid to boil or when
preparing large quanities of food.
Min-2-Max™ double burner -18,000 BTU-
Capibilities of large burner combined with a
simmer burner.
Perfect Simmer™ burner -5,000 BTU- best for
simmering delicate sauces, melting
chocolates, etc.
Operating
burner
1. Push right front surface control knob in and turn
counterclockwise out of the OFF position -Fig. 1.
(lite) position.
2. Release the knob and rotate to the
position. Note: Although all electronic surface
ignitors will spark at the same time, only the
selected surface burner will lite.
3. Visually check that both the inner and outer rings
are lit -Fig. 4.
When both burners are lit, continue to turn the
control knob counterclockwise to adjust to the
desired flame size.
4. If only the inner burner is needed, continue to
rotate the gas control knob counterclockwise
Fig. 1
somewhere past grey area -Fig. 2.
5. Adjust the inner flame to desired size -Fig. 3.
Min-2-Max™ double
(lite)
Fig. 3
Fig. 4
Fig. 2