Standard Cmos Features - Gigabyte GA-G41MT-D3 User Manual

2-4

Standard CMOS Features

Date (mm:dd:yy)
Time (hh:mm:ss)
 IDE Channel 0 Master
 IDE Channel 0 Slave
 IDE Channel 2 Master
 IDE Channel 2 Slave
 IDE Channel 3 Master
 IDE Channel 3 Slave
Drive A
Floppy 3 Mode Support
Halt On
Base Memory
Extended Memory
Total Memory
 : Move Enter: Select
F5: Previous Values
Date (mm:dd:yy)
Sets the system date.
Time (hh:mm:ss)
Sets the system time.
IDE Channel 0, 2, 3 Master/Slave
IDE HDD Auto-Detection, IDE Auto-Detection
Press <Enter> to autodetect the parameters of the IDE/SATA device on this channel.
IDE Channel 0 Master/Slave, Extended IDE Drive
Configure your IDE/SATA devices by using one of the three methods below:
• Auto
• None
• Manual
Access Mode
The following fields display your hard drive specifications. If you wish to enter the parameters manually,
refer to the information on the hard drive.
Capacity
Cylinder
Head
Precomp
Landing Zone Landing zone.
Sector
Drive A
Allows you to select the type of floppy disk drive installed in your system. If you do not install a floppy
disk drive, set this item to None. Options are: None, 360K/5.25", 1.2M/5.25", 720K/3.5", 1.44M/3.5",
2.88M/3.5".
BIOS Setup
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Standard CMOS Features
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Lets the BIOS automatically detect IDE/SATA devices during the POST. (Default)
If no IDE/SATA devices are used, set this item to None so the system will skip the
detection of the device during the POST for faster system startup.
Allows you to manually enter the specifications of the hard drive when the hard drive
access mode is set to CHS. (For IDE Channel 0 Master/Slave only.)
Sets the hard drive access mode. (Default: Auto)
Approximate capacity of the currently installed hard drive.
Number of cylinders.
Number of heads.
Write precompensation cylinder.
Number of sectors.
Tue, Oct 6 2010
22:31:24
[None]
[None]
[None]
[None]
[None]
[None]
[1.44M, 3.5"]
[Disabled]
[All, But Keyboard]
640K
2012M
2014M
F10: Save
- 28 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults