Output Level Fader & Meter; Spdif Output Meter; Mme Output Meter - ESI WaMi Rack 192 series Manual

ESI WaMi Rack 192 Series
2. Input 3,4
Under the Monitor select button, this is where to control and see input level of WaMi
Rack 192 Series through Input 3,4, which can be switched between analog and digital
channels. You can change the input level by click and drag the fader and the number at
the bottom shows you relative amount of level in dB, by clicking it you can MUTE the
channel.
9. Output level fader & meter
1,2/3,4/5,6/7,8
Output goes to Output port 1,2/3,4/5,6/7,8 directly as you set on your application unless
you click the MONIT button above the Output1,2 fader to activate input monitor
function through the Output1,2 port. Even in Input Monitoring mode, rests of the
output channels are still in direct out mode that is
Click and drag the fader to change the level. The numbers at bottom show the relative
amount of level in dB. By clicking it, you can MUTE the channel.

10. SPDIF Output Meter

It shows digital output level of WaMi Rack 192 Series.

11. MME Output Meter

1,2/3,4/5,6/7,8
You can adjust level of MME supporting software in here. MME driver output level
sometimes lower than its actual output level. In this case, you should adjust level using
this fader. The '%' of bottom means volume level indication.
Mute
When you click the number (amount of level) on bottom of each fader, selected fader
will be muted. And the number on bottom is changed to display 'Mute'.
24