Choice Of Electrical Connection; Preparing Cabinet For Fitting Of Oven - Firenzi FDU 700 Instruction Booklet

CHOICE OF ELECTRICAL CONNECTION

·
The appliance should be operated using at least
2
6mm twin core and earth PVC insulated multicore
cable. Please choose from the most appropriate
after reading the different methods.
·
By connecting the appliance to a cooker point
having a double pole isolating switch with at least
3mm contact separation in all poles and protected
with a fuse or miniature circuit breaker at your
mains fuse box.
·
If you wish to connect an oven and a hob to a
cooker point you can, by connecting the oven and
hob separately to the cooker point. Oven and hob
units should be separately connected to a cooker
point. See Fig. 4.
NOTE: It is good practice to :
·
Fit an Earth Leakage Circuit Breaker to your house
wiring.
·
Wire your appliance to the latest IEE regulations.
PREPARING CABINET FOR FITTING OF
OVEN
·
Make sure the space between the cabinets is the
correct size for the appliance to be fitted (Ref. Fig.
5 & 6).
·
The plinth board spanning the space into which the
appliance is to be installed should be removed.
·
If the size is between adjacent cabinets is 605-
610mm, then the cabinets should be modified so
that the recommended dimension of at least 600-
605mm is maintained.
·
The cabinets must be stable and level by firmly
securing it to the wall or floor. If necessary, make
arrangements to ensure the shelf upon which the
oven will rest is level.
·
The adjacent cabinets must be stable and level by
firmly securing to the wall or floor. If necessary,
make arrangements to ensure the work surface
below which the oven will rest is level.
·
Drill two pilot screw holes into the sides of the
adjacent cabinets, in the positions indicated by Fig.
5.
·
Fit the appliance mounting brackets using the two
holes indicated in Fig. 7 to the adjacent cabinets
(Ref. Fig. 5 & 6).
·
Check that the mounting brackets are level. They
can be adjusted if necessary by using the extra
holes at the ends of the brackets.
brackets are level, drill a pilot hole through the
central hole in the bracket and fit the remaining
screw.
Once the
28
Fig. 4
Fig. 5
Fig. 6
Fig. 7