How To Finish Unpacking; To Remove Cover Of Mains Terminal - Firenzi FDU 700 Instruction Booklet

HOW TO FINISH UNPACKING

·
Place packed appliance next to the space in which
it will be installed. See Fig. 8.
·
Remove the appliance packing except for bottom
tray which should be left in position until the
appliance is ready to be fitted into its cabinet.
NOTE: It is imperative that the appliance is left
in the base to protect both the appliance and
the floor.
·
Ensure the owner is given these operating
instructions.
Important: Switch off at mains, miniature
circuit breaker and, if appropriate, remove
fuse before commencing any electrical work.

TO REMOVE COVER OF MAINS TERMINAL

From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
·
First remove retaining
screwdriver. See Fig. 9.
·
Prise cover loose using screwdriver in position (1)
then lever off with screwdriver in position (2) at
either side. See Fig. 10.
·
Lift cover and remove screw from cable clamp.
See Fig. 11.
screw with pozidrive
Fig. 9
Fig.10
29
Fig.11
Fig.8