Ac Applications - Honda EMS4000 Owner's Manual

AC applications
1. Start the engine and make sure the pilot lamp comes on. If not, the
filament may be burnt out.
2. Turn the voltage selector switch to either position as required. When the
switch is turned to "12OV ONLY" position, you can use only 120V AC.
At "12OV/24OV" position, you can use both 120V and 240V receptacles.
3. Switch on the AC Circuit Breaker.
4. Plug in the appl'iance.
CAUTION: Be sure that appliances do not exceed the rated load for more
than 30 minutes, and never exceed the maximum load. Substantial over-
loading will switch off the circuit breaker. Marginal overloading may not
switch off the circuit breaker, but it will shorten the service life of the gen-
erator.
Be sure that all appliances are in good working order before connecting them
to the generator. If an appliance begins to operate abnormally, becomes
sluggish, or stops suddenly, turn off the circuit breaker and the generator
engine switch immediately. Then disconnect the appliance and examine it
for signs of malfunction.
NOTE: This generator is equipped with an AVR (Automatic Voltage
Regulator) for stable voltage supply.
PI LOT
LAMP
/
AC CIRCUIT
/BREAKER
VOLTAGE
SELECTOR
SWITCH
17