Configuring Jmicron Jmb362/Gigabyte Sata2 Sata Controller - Gigabyte GA-X58A-UD5 User Manual

5-1-2 Configuring JMicron JMB362/GIGABYTE SATA2 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. See the table below for the SATA controllers and their corresponding SATA
ports. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to Inte-
grated Peripherals. To enable RAID, see the table below for configuring different SATA Controllers for RAID.
Controller
JMicron
JMB362
GIGABYTE GSATA2_8/9
SATA2
eSATA Controller
eSATA Ctrl Mode
GSATA 6_7/IDE Controller
GSATA 6_7/IDE Ctrl Mode
GSATA RAID Configuration
GSATA 8_9/IDE Controller
GSATA 8_9/IDE Ctrl Mode
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Connectors BIOS Settings
eSATA ports Set eSATA Controller to Enabled
Set eSATA Ctrl Mode
Set GSATA 8_9/IDE Controller
Set GSATA 8_9/IDE Ctrl Mode
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
to
RAID
[Enabled]
[RAID]
[Enabled]
[IDE]
[Press Enter]
[Enabled]
[RAID/IDE]
F10: Save
Figure 1
- 97 -
to
Enabled
to
RAID/IDE
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix