Configuring Gigabyte Sata2/Jmicron Jmb362 Sata Controller - Gigabyte GA-890FXA-UD7 User Manual

5-1-2 Configuring GIGABYTE SATA2/JMicron JMB362 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. See the table below for the SATA controllers and their corresponding SATA
ports. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go
to the Onboard PCIE Devices sub-menu under the Integrated Peripherals menu. See the table below for
configuring different SATA controllers for RAID (Figure 1).
Controller
GIGABYTE GSATA2_6/7
SATA2
JMicron
JMB362
Primary Dual Slot Config
Secondary Dual Slot Config
PCIEX4_2 Slot Config
Onboard GSATA controller
Onboard GSATA Mode
Onboard ESATA controller
Onboard ESATA Mode
Onboard LAN1 Function
Onboard LAN1 Boot ROM
 SMART LAN1
Onboard LAN2 Function
Onboard LAN2 Boot ROM
 SMART LAN2
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Connectors BIOS Settings
Set Onboard GSATA controller
Set Onboard GSATA Mode
Set Onboard ESATA controller to Enabled
eSATA ports
Set Onboard ESATA Mode
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Onboard PCIE Devices
+/-/PU/PD: Value
F6: Fail-Safe Defaults
to
to
RAID
[Auto]
[Auto]
[As X1 Link]
[Enabled]
[RAID/IDE]
[Enabled]
[RAID]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Disabled]
[Press Enter]
F10: Save
Figure 1
- 87 -
to
Enabled
RAID/IDE
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix