Onboard Parallel Port - Gigabyte GA-P55A-UD3P User Manual

Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard USB 3.0 Controller (NEC D720200F1 USB Controller)
Enables or disables the NEC D720200F1 USB controller. (Default: Enabled)
Onboard IDE Controller (iTE IT8213 Chip)
Enables or disables the IDE controller integrated in the iTE IT8213 chip. (Default: Enabled)
eSATA Controller (JMicron JMB362 Chip, eSATA Connectors)
Enables or disables the SATA controller integrated in the JMicron JMB362 chip. (Default: Enabled)
eSATA Ctrl Mode (JMicron JMB362 Chip, eSATA Connectors)
Enables or disables RAID for the SATA controller integrated in the JMicorn JMB362 chip or configures
the SATA controller to AHCI mode.
IDE
AHCI
RAID
GSATA Controller (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled)
GSATA Ctrl Mode (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to decide whether to configure the SATA controller integrated in the Marvell 9128 chip to
AHCI mode.
IDE
AHCI
GSATA RAID Configuration (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to configure RAID for the Marvell 9128 SATA controller. Refer to Chapter 5, "Configuring
SATA Hard Drive(s)," for instructions on configuring a RAID array.
Onboard Serial Port 1
Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.

Onboard Parallel Port

Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and correspond-
ing interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
Disables RAID for the SATA controller and configures the SATA controller to IDE
mode. (Default)
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
Enables RAID for the SATA controller.
Configures the SATA controller to IDE mode. (Default)
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
- 53 - BIOS Setup