Playback; Menu Operation - Denon AVR-A100 Owner's Manual

Playback

1
ZONE SELECT
Press to switch the
zone mode to (ZONE2) or
Z2
(ZONE3).
Z3
2
AMP
Press .
3
ZONE/DEVICE ON
Press to turn
on the ZONE2 or ZONE3 power.
The or indicator on the
display lights.
• Also press input source select button when
in standby mode, the power turns on.
ZONE/DEVICE OFF
• When is pressed,
ZONE2 or ZONE3 turns off.
• Power in ZONE2 or ZONE3 can be turned
ZONE2 ON/OFF
on or off by pressing or
ZONE3 ON/OFF
on the main unit.
4
Press the input source select button.
The audio signal of the selected source is output to ZONE2 or
ZONE3.
SOURCE SELECT
• Turn after
ZONE2/3 / REC SELECT
pressing
on the main unit to select an
input source.
When power for both MAIN ZONE and ZONE2 (ZONE3) is set to ON,
power of the MAIN ZONE only can be turned off. Select
ZONE/DEVICE OFF
ZONE) in step 1 then press
Adjusting the volume
VOL df
Use to adjust the volume.
GAdjustable rangeH – – –
(When the "Volume Display" (vpage 104) setting is "Relative")
GAdjustable rangeH
(When the "Volume Display" (vpage 104) setting is "Absolute")
• At time of purchase, "Volume Limit" (vpage 103) is set to "–10dB
(71)".
Input source
MASTER VOLUME
Turn
select buttons
main unit to adjust the sound volume.
Turning off the sound temporarily
MUTE
Press .
The sound is reduced to the level set at "Mute Level" (vpage 103) in
the menu.
• To cancel, either adjust the volume or press
• The setting is canceled when the zone's power is turned off.
M (MAIN
.
–80dB – –40dB – 18dB
0 – 41 – 99
ZONE2/3 / REC SELECT
after pressing on the
MUTE
again.

Menu Operation

The settings related to tone adjustment and volume can be made.
1
In the zone mode for which you
want to operate, press MENU.
The ZONE2 or ZONE3 menu is displayed
on the ZONE2 TV.
MENU ZONE2
INPUT :SAT/CBL
SIGNAL:ANALOG
VOL. :-40dB
>Bass 0dB
Treble 0dB
HPF OFF
Lch Lev. 0dB
Rch Lev. 0dB
MENU ZONE2
>Channel STEREO
Vol.Lev. - VAR -
Vol.Limit -10dB
P.On Lev. LAST
Mute Lev. FULL
2
Press to select the menu to be set or
uio p
operated.
3
Press MENU to enter the setting.
The on-screen display disappears.
• For ZONE2, the "Zone Setup" can be made while watching the
on-screen display.
Also, when ZONE3 is operated, the on-screen display appears on
the ZONE2 monitor, so operation can be performed watching this
on-screen display.
• You can adjust these setting in "Zone Setup" (vpage 103) in the
menu.
ENGLISH
73