Add Device - Barco DC Toolset User Manual

4. Configurator
4.5 Add device to a configuration
This chapter describes how to add a device, projector or touch panel to a configuration
without scanning the complete network for all possible devices.
Overview
•

Add device

• General properties
• Set up a Ethernet connection
• Decorator setup
4.5.1 Add device
The possible device types depends on the installed plug-ins.
About adding a device
To make it more easy to find back a device, projector or touch panel while adding it to the software, the
different devices are grouped in categories.
The following categories are available for the moment (depending on the loaded plug-ins):
• Digital cinema: contains all supported digital cinema projectors.
• Digital cinema, contains all supported touch panels (DCTP)
How to add
1. Click Configuration on the menu and select Add (a). (image 4-4)
2. Move the cursor to the right and select the desired category.
3. Move the cursor again to right and select the desired projector.
The Create projector dialog box opens with the selected device type pictograph at the right side (b).
4. Enter the different device properties such as the projector identification, the connection parameters and
projector decorator for the configuration preview.
28 R59770449 DC TOOLSET 15/12/2009