Table of Contents
Advertisement
Creating a Security Array with Existing Data Drive
If you would like to use an existing drive that already contains data and/or
is the bootable drive in your system, make sure that the new hard drive
you will use in the array has the same or larger capacity as the existing
drive.
Backup all important data before creating an array. Failure to do so
may cause data loss.
1. In the FastBuild™ utility main menu, press "1" to select Auto Setup.
2. Use the arrow keys to go to the field
" Security " with the space bar. The
3. Press <Ctrl-Y> to save your selection. The following message appears:
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
5. Press "Y" for the Create and Duplicate option. The following window
prompts you to select the source drive to use.
6. Use the arrow keys to select the source drive. The FastBuild utility will
copy all the data from the source drive to the target drive.
7. Press <Ctrl-Y> to save the selection and start the duplication. The
following message appears:
Start to duplicate the image...
Do you want to continue? (Yes/No)
Y - Continue
8. Select "Y" to continue. If you select "N", you will be returned to the
main menu.
9. When the duplication process is completed, the following message
appears confirming that your Security array has been created.
10. Press any key to reboot the system.
11. Install the RAID driver from the support CD that came with the
motherboard package.
Depending on the operating system you are installing (or that is
already installed), the RAID driver installation sequence may vary.
5-30
Mode
N - Abort
Optimize Array for
field displays " Mirror ".
Chapter 5: Software support
and select
Advertisement
Table of Contents
