Remote Control Battery Replacement - Sonic Frontiers THE LINE SERIES Owner's Manual

TEC HNI C A L SP EC I FIC A TI O NS
LI N E 3 TE CH NIC AL SP EC IFIC ATI ON S
Frequency Response 2 Hz to 250 kHz +/- 0.5 dB
> 1 MHz -3.0 dB at 2 VRMS output
THD & N* < 0.01% from 20 Hz to 20 kHz Unbalanced
(single-ended) or Balanced output at 2 VRMS
Gain 18 dB @ 1 kHz (balanced)
12 dB @ 1 kHz (single-ended/unbalanced)
Input Impedance 21k ohms - balanced
Output Impedance 90 ohms balanced output
45 ohms single-ended
Maximum Input 8.0 VRMS maximum (balanced)
4.0 VRMS (single-ended)
Rated Output 2 VRMS (balanced)
1 VRMS (single-ended)
Maximum Output 56 VRMS at 1% THD (balanced output)
V o l t a g e
Noise < 50µV unweighted wideband noise*
Approx. 22µV IHF A-weighted noise (balanced)
-100 dB A-weighted below a 2 VRMS output
Stereo Separation > -100 dB @ 1kHz relative to 2V RMS input
(Crosstalk)
Tube Complement 10 - 6922 (6DJ8 types)
2 - 6GH8A
Fuse Requirements (1) 2A/250V slow-blo (110-120VAC countries)
1A/250V slow-blo (220-240VAC countries)
Power Requirements 135VA Operate
75VA Standby
Dimensions 19" Wide x 14.25" Deep x 4.5" High
(each chassis) (48 cm x 36 cm x 11.5 cm)
Net Weight Approx. 60 lbs (27.5 kg) - unpacked
Relay Trigger 30ma AC or DC
(Contacts) 30V max. isolated from chassis via
3.5 mm stereo jack
Infra Red Jack Maximum input voltage 12Vp-p
3.5 mm stereo jack
C O N T ' D
REMO TE C ONTRO L TEC HN ICA L
S P E C I F I C A T I O N S
Infra Red Wavelength
Battery
Dimensions
Weight
REMOT E CO NT RO L BAT TER Y R EPL A CEM ENT
To replace the remote control batteries, unscrew the top of the
remote from the base and insert batteries as shown below.
Note: All measurements performed with an Audio Precision System Two test center.
"*" Indicates measurement determined within an 80kHz bandwidth.
Due to Sonic Frontiers desire to continually improve its products, specifications are
subject to change without notice.
890nm (nanometers)
2 AAA 1.5V
3" Diameter X 1 1/8 " H
.1395 Kg (.31 lbs)
15