Table of Contents
Advertisement
To install the optional Omnimount bracket to the enclosure, do the following:
NOTE:
This procedure is not illustrated.
Tools: #2 Phillips screwdriver.
Remove four (4) M8 flat head screws from the back of the loudspeaker enclosure.
1.
Position the optional Omnimount bracket over the bolt holes on the back of the enclosure.
2.
Apply thread locker (not included) to the four (4) M8 Pan head screws.
3.
Securely fasten the four (4) M8 pan head screws to the back of the enclosure and bracket.
4.
REFERENCE:For more information, see the manufacturers's technical documentation to complete the installation.
Set the desired angle.
5.
Optional M8 Forged, Shoulder-Style Closed Eyebolt
The Optional M8 Forged, Shoulder-Style Closed eyebolt is used for rigging. Any of the six (6) heavy duty T-nut mounting
points can be used for rigging with an M8 forged, shoulder-style closed eyebolt (purchased separately).
NOTE:
Due to the counterbore on the enclosure, a fender style washer is required to assemble the eyebolt.
WARNING:
Eyebolts used for rigging EVU loudspeaker systems in this manner must be made for rigging purposes i.e.
forged shoulder-style closed design with a listed WLL (Working Load Limit) within the specifications
called out in this manual.
WARNING:
Only one (1) loudspeaker may be rigged with the optional eyebolt. The loudspeaker is not designed to hold
the weight of additional cabinets, as with clusters.
To install the optional M8 forged, shoulder-style closed eyebolt to the case, do the following:
NOTE:
This procedure is not illustrated.
Tools: #2 Phillips screwdriver.
Parts: M8 forged, shoulder-style closed eyebolt(s).
Fender washer for each eyebolt.
NOTE: Fasten up to six (6) M8 eyebolts (four [4] on top and one [1] on each end) to the loudspeaker enclosure
according to your mounting requirements.
Remove any M8 flat head screws from positions you intend to install an M8 forged, shoulder-style closed eyebolt.
1.
IMPORTANT: If only one (1) eyebolt is used to rig the loudspeaker, the installer must use a threadlocker to
prevent the loudspeaker from spinning out of the eyebolt during operation.
Position the M8 fender washer(s) over the desired mounting point(s).
2.
Apply threadlocker to the threads of the M8 forged, shoulder-style closed eyebolt(s), as recommended by the
3.
manufacturer.
Install the M8 forged shoulder-style closed eyebolt(s) to the case, ensuring the eyebolt is fully seated.
4.
WARNING:
Mounting to the structure is the responsibility of others.
Installation
23
Advertisement
Table of Contents
