Load Default Settings; Load Non Disk - ECS IC890GXM-A Manual

44

Load Default Settings

This option opens a dialog box to ask if you are sure to install optimized defaults or
not. You select [OK], and then press <Enter>, the Setup Utility loads all default
values; or select [Cancel], and then press <Enter>, the Setup Utility does not load
default values.

Load Non Disk

1. The default value of the item "Onboard LAN Boot ROM" is " Disabled" accord-
ingly since the item "Load Non Disk" is set to "Disabled".
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard SATA Mode
SATA Configuration
SATA 6.0 Gbps Support
Onboard AUDIO Function
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
USB Functions
Legacy USB Support
2. You may highlight this option and press <Enter> to Enable it.
CMOS Setup Utility -- Copyright (C) 1985-2009, American Megatrends, Inc.
Standard CMOS Setup
Advanced Setup
Advanced Chipset Setup
Integrated Peripherals
Power Management Setup
PCI/PnP Setup
PC Health Status
3. Reboot.
Integrated Peripherals
Enabled
IDE
Enabled
Enabled
Enabled
Disabled
3F8/IRQ4
Enabled
Enabled
: Move Enter : Select +/-/: Value
F1:General Help F9: Optimized Defaults
M.I.B. III (MB Intelligent BIOS III)
Load Default Settings
Load Non Disk
Supervisor Password
User Password
Load Non Disk?
Save & Exit Setup
[Ok] [Cancel]
Exit Without Saving
: Move
Enter : Select +/-/: Value
F1:General Help
F9: Optimized Defaults
v02.62 (C)Copyright 1985-2008, American Mega trends, Inc.
Using BIOS
Help Item
Options
Disabled
Enabled
F10: Save ESC: Exit
F10: Save ESC: Exit