Section Two - Editing Functions; Editing/Creating Presets - DigiTech BP90 Owner's Manual

Section Two - Editing Functions

Editing/Creating Presets

The BP90 is designed to make preset editing and creation easy and intuitive. When creating your
own sound, you must first start with an existing preset. Note that the preset you begin with
doesn't have to be in the memory location you intend to have it reside, since you can store it to
any User preset location during the store procedure.
The easiest way to start is by using the Tone Library and Effects Library buttons. The Tone
Library button gives you access to a variety of pre-programmed amp/distortion tones (see page
37) based on different musical styles. The Effects Library button then lets you select from a pal-
ette of effects chains (see page 38), from simple delays to full multi-effect signals with modulation,
delay and reverb. Use the Effects Level Button to easily increase or decrease the Chorus/FX,
Delay and Reverb levels if desired. Using these three controls should get you close to a sound you
are after. From there you can then use the Edit buttons to select individual Effects, and the Value
Up/Down buttons to adjust their settings.
To edit and create a custom preset:
1. Use the Footswitches to select the preset you wish to edit. If you are trying to find some-
thing different from the existing presets, begin by using the Tone Library, Effects Library,
Effects Level and Value Up/Down buttons to get close to a sound you want.
2. Once you have a sound close to what you are after, begin editing the Effects by pressing the
Edit Up/Down buttons and selecting the Effect you want to adjust.
To turn an Effect on, select it with the Edit Up/Down buttons. Each Effect has multiple set-
3.
tings to select from. Use the Value Up/Down buttons to change the values for the selected
Effect To turn an Effect off, press and hold the Value Down button until Ofappears in the
Display. (For EQs, b5, d5, and t5 are the settings with no boost or cut.)
16