DigiTech BP90 Owner's Manual page 9

up. The right 6 red LEDs indicate the note is sharp and should be tuned down. The center LED
indicates the note is in tune. The output is muted in Tuner mode; rock the Expression Pedal to
regain volume.
Left LEDs indicate
note is flat
In Tuner mode, you can change your tuning reference with the Value Up/Down buttons. The
default factory setting is A=440 Hz (displayed as 40). Other tuning references are A=A flat (dis-
played as Ab), A=G (displayed as ), and A=G flat (displayed as b). The display window will briefly
flash the currently selected tuning preference.
Exit Tuner mode by pressing either Footswitch.
Center LED indicates
note is in tune
NOISE GATE
NOISE GATE
CHORUS/FX
CHORUS/FX
EQUALIZER
EQUALIZER
AMP / DISTORTION AMP / DISTORTION
IN TUNE
COMPRESSOR COMPRESSOR COMPRESSOR
FRETLESS / WAH FRETLESS / WAH
PRESET LEVEL
PRESET LEVEL
VALUE
EDIT
TONE LIBRARY EFFECTS LIBRARY EFFECTS LIBRARY
TONE LIBRARY
Display shows
note played
BASS BASS
DELAY DELAY
REVERB
REVERB
EXPRESSION EXPRESSION
PATTERN
PATTERN
TEMPO
TEMPO
LEVEL
LEVEL LEVEL
DRUMS DRUMS
STORE
EFFECTS LEVEL EFFECTS LEVEL MASTER LEVEL MASTER LEVEL
Right LEDs indicate
note is sharp
3