Advertisement
Table of Contents
TS3 Floor Sensor
Installation Instructions
Mounting
The fl oor sensor is recommended to be placed
in an installation pipe.
The fl oor sensor should be placed between two
pipes and near to the fl oor surface.
Specifi cations
10KΩ±2% @ 25ºC
Encapsulated in Ø8mm x 50mm long Copper
Tube 2 meter PVC cable.
With end-stripped outer sheath 10mm, inner
core insulation 5mm.
Wiring
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also
applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specifi cations already agreed.
Floor sensor wiring
to thermostat
Part No: 3498v01 08/07
Advertisement
Table of Contents
Need help?
Do you have a question about the TS3 and is the answer not in the manual?
Questions and answers