Ftgcard Mode Of Operation Overview - LG 42LH250H Owner's Manual

FTG Card Mode of Operation Overview
Outlined below is the FTG (Free-To-Guest) setup for individual TV control
1. Set up commercial features of TV/STB. Enter Installer Menu and set all desired items as required. (i.e. Tuning
Band, Start Channel etc.) Refer to the Installation and Setup Guide of the TV/STB.
2. Load the FTG Configuration Application program onto the PC that will be used to configure the FTG card.
3. Install FTGcard into TV/STB's MPI card slot and connect PC. (See below)
4. Execute the FTG Configuration Application and create a configuration file.
5. Build a Channel Map and 'Write' it to FTG card. (Converts card from pass-through to FTG mode.)
6. If necessary, make changes to Installer Menu items using FTG Installer Menu Configuration utility and 'Write'
them to FTGcard.
7. Save the configuration file (_.rml) for future use.
8. Tune TV/STB to a Logical Channel in the Channel Map.
LMTTZ7 Configured Card in FTGMode of Operation
FTG CARD TA RGET TV/STB
I
INSTALLER [q INSTALLER
MENU I MENU
CHANNEL CHANNEL
MAP MAP
Different Model TV/STB Function
Cardonly copies Installer Menu items
and then installs Channel Map,
FTG CARD
INSTALLER
M ENU
CHANNEL
MAP
TA RGET TV/STB
_1 INSTALLER
M ENU
CHANNEL
MAP
Same Model TV/STB Function
Card installs both Installer Menu items
and Channel Map,
RETAINING SCREW
Install after inserting
the LMT7Z7card,
RETAINING SCREW
Install after inserting
the LMT7Z7card,
®
3> O z
Z
®
-- ANTENNA/CABLE INPUT
ReceivesRFsignals.
M.P.I. INTERFACE
Available MPI port.
206-4118 P A G E 9