Table of Contents
Advertisement
The light will turn off when the button is released.
Caution! Always point the light away from you and the eyes of others.
This is a bright high intensity LED which should not be directed toward
or into the eyes of anyone.
QUICK REFERENCE CHART:
You can program any individual channel without reprogramming all
channels. To go directly to a particular receiver channel follow the
chart below:
CHANNEL
1 Ign. On Then
Press and Release 3 Times
2 Ign. On Then
Press and Release 4 Times
3 Ign. On Then
Press and Release 5 Times
4 Ign. On Then
Press and Release 6 Times
5 Ign. On Then
Press and Release 7 Times
6 Ign. On Then
Press and Release 8 Times
BATTERY REPLACEMENT:
The transmitter incorporates a small LED visible through the case which
is used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates. Transmit-
ter battery replacement is recommended at least every 10 to 12 months,
depending upon how frequently the transmitter is used.
To replace the battery:
1) Remove the small # 0 Phillips head screw from the rear of the case.
2) Remove the rear cover to access the discharged battery paying
attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, close the
case, then reinstall the small case
screw removed in step 1.
5) If you accidently dislodge the cir-
cuit board from the transmitter hous-
ing, be certain that the rubber mem-
brane is seated properly, and the
buttons are properly exposed from
the front view of the case, then
insert the circuit board, and return
to step #4.
VALET SWITCH
5
LED
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
6 Flashes
128-6516A
5 of 8
Advertisement
Table of Contents
