Connections - Pioneer SEP C1 - Software Entertainment Controller Operating Instructions Manual

CONNECTIONS

CONNECTIONS
Use the accessory USB auxiliary power cable and the normal USB cable to connect the unit to the computer (connect the USB auxiliary
power cable first).
Computer
Mixer
NOTE
• Do not connect anything to the 5 V connector other than the accessory USB auxiliary power cable.
• Always use the accessory USB auxiliary power cable and USB cable only.
• Always connect the accessory USB auxiliary power cable and USB cable to one and the same computer.
• Do not connect this unit to a computer through a USB hub.
• Do not connect this unit to a computer through a CardBus-supported USB interface card.
Connection to external monitor (pin-jack connector)
Use these connections when you wish to output the center display images to a large screen. After connecting this unit to the external
monitor, the unit's settings must be changed (see the item "MONITOR OUT" in the topic "[1] DISPLAY" under the section "USING THE
UTILITY" on P. 25).
External monitor
Accessory USB cable
Accessory USB auxiliary
power cable.
Audio interface (sold separately)
Audio cable
Do not connect the USB auxiliary power cable or USB
cable until the driver software has been installed in the
computer.
PC
5V
MONITOR OUT
PC
5V
MONITOR OUT
REMOTE
CONTROL
REMOTE
CONTROL
9
En