Important Information; Ecologically Responsible Disposal Of Packaging; And Old Appliances; Electrical Connections - AEG MCC 663 Instruction Manual

Important information

i

Ecologically responsible disposal of packaging

materials and old appliances
Packaging materials
¤
)
AEG microwave ovens require effective packaging to protect them during
transportation. Only the minimum packaging necessary is used.
Packaging materials (e.g. foil or styrofoam) can place children at risk.
!
Danger of suffocation. Keep packaging material away from children.
¤
All packaging materials used are environmentally friendly and can be recycled.
)
The cardboard is made from recycled paper and the wooden parts are
untreated. Plastic items are marked as follows :
«PE» polyethylene eg packaging film
«PS» polystyrene eg packaging (CFC-free)
«PP» polypropylene eg packaging straps
By using and re-using the packaging, raw materials are saved and waste
volume is reduced.
Packaging should be taken to your nearest recycling centre. Contact your
local council for information.
Disposal of old appliances
Old appliances should be made safe before disposal by removing the plug,
and cutting off and disposing of the power cable.
¤
It should then be taken to the nearest recycling centre. Check with your
)
local Council or Environmental Health Office to see if there are facilities in
your area for recycling the appliance.
Installation
The oven should be set at least 85 cm above floor level. Make sure that
nothing obstructs the ventilation louvres at the back of the appliance and
that the electrical plug will be accessible after installation. Please refer to
the installation manual included with your oven for further instructions.
Do not use your appliance immediately (wait approx. 1-2 hours) after transfer
from a cold place to a warm place as condensation may cause a malfunction.
!

Electrical connections

•
WARNING! THIS APPLIANCE MUST BE EARTHED. The manufacturer
declines any liability should this safety measure not be observed.
This appliance complies with the following EC Directives :
EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC with amendment
90/683/EEC and the CE marking Directive 93/68/EEC.
5