LaCie Professional Server
Technical Brief: RAID
7.4. Boot Order and Creating the
System Mirror
All Windows Storage Server system files are duplicated on each disk
in the mirror. In most instances, when there are two versions of a
Windows operating system, the user is prompted to select one as the
device boots. Since a monitor and keyboard are required to choose
the boot disk, your 5big Storage Server has turned off this option to
save the user time when booting the device.
EXAMPLE:
By default, the 5big Storage Server boots from the first
disk with an operating system. In this case, that is Disk 0. If Disk 0
should experience a problem or the operating system is damaged,
the 5big Storage Server will boot from Disk 1 without forcing any
action from the user. However, this option will be lost if the user has
performed a recovery and reinstalled Windows Storage Server or is
adding additional drives to a single disk 5big Storage Server.
In the scenario where Disk 0 fails some time after a disks were added
to a single disk 5big Storage Server, the front LED will blink continu-
ously since it cannot boot from the first drive with an operating sys-
tem. The administrator may feel a bit inconvenienced by having to
connect a monitor, keyboard, and mouse to the 5big Storage Server
in order to choose Disk 1 as the boot disk.
To keep the 5big Storage Server boot order, type or copy and paste
the following commands into Command Prompt before mirroring
the system disk (Go to Start>Command Prompt or Start>Run
and type cmd.):
bcdedit /set {current} osdevice boot
bcdedit /set {current} device boot
bcdedit /set {bootmgr} device boot
bcdedit /set {memdiag} device boot
Please go to
7.5. Creating the System
Mirror.
RAID - Three Disks
page 48