Brother FAX-8650P - B/W Laser - Fax Service Manual page 79

(4) Remove the screw and take off the NCU PCB from the NCU bracket.
n n
Reassembling Notes
• When setting the NCU PCB to the NCU bracket, fit its edges onto "b" and "c" and into "a" and
"d" as illustrated above.
• First bind the NCU harness and NCU harness 2 together with the ferrite core NF-80 so that the
NF-80 comes near to the binder on the NCU harness 2 as shown above, and connect those
harnesses to the main PCB. Then hook them to the two latches and route them between the
two bosses as illustrated on the previous page.
IV - 41